Controls
AccuColor
AccuColor
ACCUCOLOR
Setting 1, 2, 3, and 5 can be adjusted. For each of these settings the following
levels can be adjusted: Color temperature, Red, Yellow, Green, Cyan, Blue, and
Magenta.
The sRGB and NATIVE, color presets are standard and cannot be changed.
The PROGRAMMABLE setting can only be adjusted using color calibration software
such as NEC's GammaComp or Spectraview II.
Tools
Tools
SHARPNESS: This function is digitally capable of keeping a crisp image within any
resolution at any time. This setting can be set independently for different signal
timings (resolution settings).
DVI SELECTION: This function selects the DVI input mode. If the DVI selections changes,
you must restart the computer.
AUTO: When using the DVI-D to DVI-D cable, the DVI SELECTION is DIGITAL.
When using the D-SUB to DVI-A cable, the DVI SELECTION is ANALOG.
DIGITAL: DVI digital input is available.
ANALOG: DVI analog input is available.
NOTE: When using a MAC with digital output: before turning on the MAC, the
DVI Input mode on the monitor must be set to DIGITAL in the DVI SELECTION
menu. To set the DVI SELECTION to "DIGITAL" press the SELECT button then
CONTROL button when the DVI signal cable is connected to the DVI-I connector
of the monitor. Otherwise the MAC may not turn on.
NOTE: Depending on the type of PC/Video card or the type of video signal
cable used, the DVI SELECTION function may not operate.
VIDEO DETECT: Selects the method of video detection when more than one video
input source is connected to the monitor.
FIRST: If "FIRST" is selected as the VIDEO DETECT option, the
monitor displays the signal from the fi rst input port. If there is no signal present
at the fi rst input port, then the monitor will search for a signal from the next
input port.
If a new input signal is connected to another of the monitor's input ports while
the monitor is in FIRST mode, the monitor DOES NOT automatically
SWITCH to the new source.
– continued
Control Systems
®
CONTROL SYSTEM: Seven preset color settings.
®
12