Layout And Items Supplied - EINHELL GE-SC 35/1 Li Solo Manual De Instrucciones

4) after the equipment strikes a foreign body.
Inspect the equipment for damage and carry
out any necessary repairs before you restart
and use the equipment;
if the equipment begins to experience excep-
tionally strong vibrations, switch it off immedi-
ately and check it;
5) search for damage;
6) repair the damaged parts as required;
7) examine the equipment for loose parts and
tighten them well.
Never operate the equipment in poor weather
conditions, especially if there is a risk of lightning.
Avoid abnormal working postures and always
keep your balance so that you maintain a steady
foothold on inclines at all times.
Warning! Do not touch any dangerous moving
parts before you have pulled out the safety plug
and the dangerous moving parts have come to a
complete standstill.
Warning! Risk of injury from dangerous moving
parts!
1.3.4 Maintenance and storage
a) Make sure that all nuts, bolts and screws are
tightened securely and that the equipment is
in a safe working condition.
b) Routinely check the catch basket for signs of
wear and impaired functionality.
c) For your own safety, replace worn or dama-
ged parts without delay.
d) Remember that on equipments with teeth
units, the movement of one teeth unit may
result in the other teeth units starting to rotate.
e) While you are adjusting the equipment, take
care not to jam your fi ngers between moving
teeth and stationary parts of the equipment.
f) Allow the motor to cool before you put the
equipment away for any extended period of
time.
g) While you are carrying out maintenance work
on the teeth, it is important to remember that
the teeth can still be moved even if the drive
has been switched off .
h) For your own safety, replace worn or dama-
ged parts without delay. Use only original
spare parts and original accessories.
i) If the equipment is stopped for maintenance,
inspection or storage purposes or in order
Anl_SA_GE_SC_35_1_Li_Solo_SPK8.indb 31 Anl_SA_GE_SC_35_1_Li_Solo_SPK8.indb 31
GB
to replace an accessory, you must switch off
the drive, pull the safety plug from the equip-
ment and make sure that all moving parts
have come to a complete standstill. Allow the
equipment to cool before carrying out any
inspections, adjustments, etc. Treat the equip-
ment with care and keep it clean.
j) Keep the equipment where it is out of
children's reach.
Service
Have your power tool repaired only by trained
personnel using only genuine spare parts.
This will ensure that your power tool remains safe
to use.

2. Layout and items supplied

2.1 Layout (Fig. 1/2)
1. ON/OFF switching bar
2. Safety lock-off
5. Top push bar
6. Bottom push bar
7. Push bar bracket
8. Depth adjustment
9. Battery cover
10. Ejector fl ap
12. Cable clips
13. Quick-release fastener
14. Allen key
16. Rear wheel
17. Washer
18. Screw for quick-release fastener
19. Screw for rear wheel
20. Safety plug
2.2 Items supplied
Please check that the article is complete as
specifi ed in the scope of delivery. If parts are
missing, please contact our service center or the
sales outlet where you made bought the product
within the maximum days indicated by the con-
sumer protection laws of your country and upon
presentation of a valid bill of purchase. Also, refer
to the warranty table in the service information at
the end of the operating instructions.
•
Open the packaging and take out the equip-
ment with care.
•
Remove the packaging material and any
packaging and/or transportation braces (if
available).
•
Check to see if all items are supplied.
•
Inspect the equipment and accessories for
transport damage.
- 31 -
07.08.2017 11:12:03 07.08.2017 11:12:03