PRESIDENT HARRY III Manual Del Usuario página 37

To memorize: Select the channel to be memorized.
- press 1 second the MEM key; «MEM» appears in the display. If the KEY BP function is
activated a long beep confi rms the saving.
To delete a memory:
- switch off the transceiver.
- keep the MEM key pressed and switch on the transceiver.
- the memory is deleted.
MEM
(short press)
To recall a memory:
- press MEM shortly, «MEM» appears on the display. If the KEY BP function is activated
a beep sounds. The memorized channel is actived.
11) AM/FM ~ LOCK
AM/FM
This switch allows selecting the AM or FM modulation. Your modulation mode has to
correspond to the one of your correspondent.
Amplitude modulation/AM: is for communications in areas where there are obstacles
and over medium distances.
Frequency modulation/FM: for nearby communications in fl at, open fi eld.
LOCK
Allows to lock all the keys on the front pannel, the rotary knob and UP / DN keys on
the microphoe. An error beep sounds when a key is used and the LOCK function
is activated. A short press on LOCK activates/deactivates the LOCK function.
appears on the display when the function is activated.
Transmission (mike or vox) and reception remain active.
12) 6 PIN MICROPHONE PLUG
The plug is located on the front panel of the transceiver and makes the setting of
the equipment into the dashboard easier.
See cabling diagram page 55.
13) PTT
Transmission key, press to transmit a message,
to an incoming communication.
A) DC-POWER TERMINAL (13,2 V)
B) ANTENNA CONNECTOR (SO-239)
C) JACK FOR OPTIONAL VOX MIKE (Ø 2.5 mm)
D) EXTERNAL SPEAKER JACK (8
Ω
37
is displayed and release to listen
, Ø 3,5 mm)