Technical Data; Power Requirements - Truper SOT-250CL Instructivo

Technical data

Rated voltage with no load
Current adjust range
Type of cooling
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING

Power requirements

WARNING • The welding machine shall be perfectly grounded before
operating and ground shall not be disconnected before finishing the welding job;
otherwise the operator may receive an electric shock and get severely injured.
• There shall be a parallel connection when the tool is using the same ground
together with other tools. Never connect a series of devices.
• The gauge in the ground conducting cable cannot have a lower
CAUTION
gauge then the power cable.
CAUTION • The connection to the power source shall be carried out by a
professional electrician and should follow the electric diagram shown to the right.
• Always confirm that the input connection
CAUTION
board configuration matches with the voltage of the power
supply to which the welding machine will be connected (110 V ˜
or 220 V ˜ ). The connection screws shall be tightly fastened.
CAUTION • The power source shall meet the following
requisites:
Switch
Power cord
* The fuse fusion current is double of its rated current.
If extensions are required between the welding machine and the
work piece, the welding cord gauge shall be increased in order to
keep the welding machine energy output with a potential drop not
higher than 4 V ˜
Code
Description
Voltage
Frequency
Current
Power
Duty cycle
Output values specified are with a 68 ºF
IP Grade
Insulation
0.009 in
SOT-250CL
13107
Stick welder
Input
110 V ˜
60 Hz
66 A
7,3 kVA
Output
60 A - 130 A
1 minute work per 9 minutes rest.
Temperatures higher than the work cycle may be reduced.
IP21S
Class I
Power Cord Grips: Type Y
Tool Build Quality: Basic insulation.
The class of thermal insulation of the windings: Class H
60 A
2
220 V
˜
46 A
10 kVA
50 V ˜
60 A - 180 A
Fan
Authorized Service Center.
Ground
connection bolt
F
Output
Input diagram in the connections board
R 110 V ˜ S R
220 V ˜
ENGLISH
Power source
input
(220 V ˜ or 110 V )
˜
S
3