Schumacher CR8 Manual Del Usuario página 6

USING THE CABLE CONNECTORS
1. Connect the cable connector to the charger. Make sure to place the charger
on a dry, non-flammable surface.
2. With the charger disconnected from the wall outlet, connect the cable connector
by connecting the yellow connector to the yellow connector on the end of the
charger cable. Connect the other end of the cable connector to the battery or
ride-on toy charging outlet.
NOTE: Never connect the cable connectors together for use in other applications,
such as external battery or other power source charging, or to extend the output
cable length, as reverse polarity and/or overcharge conditions will occur.
QUICK CHARGE
When the CHARGING/CHARGED
Unplug the charger from the wall outlet and then disconnect the charger from the battery.
COMPLETE CHARGE
When the CHARGING/CHARGED
maintain mode of operation. When ready to use, unplug the charger from the wall outlet
and then disconnect the charger from the battery.
CHARGING TIMES
APPLICATION
RIDE-ON TOY
Times will vary, depending on the battery's level of discharge.
NOTE: For longer battery life, the battery must be completely charged after two
consecutive quick charges (example: quick-quick-complete).
MAINTAIN MODE (FLOAT MODE MONITORING)
When the CHARGING/CHARGED
mode. In this mode, the charger keeps the battery fully charged by delivering a
small current when necessary.
ABORTED CHARGE
If charging cannot be completed normally, charging will abort. When charging
aborts, the charger's output is shut off, and the BAD BATTERY
Do not continue attempting to charge the battery. Have the battery checked and
replace, if necessary.
BATTERY CHARGING TIME (hours)
SIZE 80% charged 100% charged
5 Ah 2
15Ah 5
LED begins to flash, the battery is ready to use.
LED turns off, the charger has switched to the
4
9
LED turns off, the charger has started maintain
• 6 •
LED will light.