Control Panel - Schumacher CR8 Manual Del Usuario

7.

CONTROL PANEL

LED INDICATORS
POWER (green) LED solid – There is AC power supplied to the charger.
CHARGING/CHARGED (green) LED solid – The charger is charging
the battery.
CHARGING/CHARGED (green) LED flashing – The battery is 80% charged
and may be used.
CHARGING/CHARGED (green) LED off – The battery is fully charged.
BAD BATTERY (red) LED solid – The battery is bad.
NOTE: See Operating Instructions for a complete description of the charger modes.
8. ASSEMBLY INSTRUCTIONS
8.1 Remove all cord wraps and uncoil the cables prior to using the battery charger.
9. OPERATING INSTRUCTIONS
BATTERY INFORMATION
This charger can be used with 24V batteries.
CHARGING
NOTE: Examine the battery for excessive wear, cracks, bulging or damage each
time you charge it. If damage is detected, do not charge the battery; replace it
immediately. If the battery is hot, allow it to cool before charging.
1. Cable Connectors (included) are necessary in order to charge ride-on toys.
See Replacement Parts for more information. Select the proper output cable
by matching the cable connector to the vehicle's battery connector.
2. Connect the battery, following the Using the Cable Connectors section.
3. Connect the charger to an electrical outlet. The POWER
4. If you've connected everything correctly, the CHARGING/CHARGED
LED should light, indicating that the charger is charging. The POWER
will remain lit.
5. When the CHARGING/CHARGED
80% charged and can be used.
6. When the battery is fully charged, the CHARGING/CHARGED
IMPORTANT: This charger does not have an ON/OFF switch. ON and OFF are
controlled by plugging in the charger to the AC wall outlet. The charger will not
supply current to the connector until a battery is properly connected.
LED begins to flash, the battery is
• 5 •
LED will light.
LED
LED will turn off.