Dremel 8100 Instrucciones De Funcionamiento Y Seguridad página 19

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1600A012FW_8100 1/30/17 12:27 PM Page 19
Store accessories in a dry and temperate environment to avoid corrosion and deterioration.
The number and variety of accessories for the Rotary Tool are almost limitless. There is a category
suited to almost any job you might have to do and a variety of sizes and shapes within each
category which en ables you to get the perfect accessory for every need.
COLLETS
If you expect to use a variety of accessories,
we recommend that in the beginning you
purchase a complete set of four collets. Store
these so that you will have the proper size of
collet for any accessory or drill bit you want
to use. Currently, the 1/8", 3/32",1/32" and
1/16" collets accommodate all of the avail -
able Dremel accessories. 1/8" collets are
included in most rotary tool kits.
MANDRELS
A mandrel is a shank with a threaded or screw
head, which are required when you use
polishing accessories, cutting wheels, sanding
discs, and pol ish ing points. The reason
mandrels are used is that sanding discs,
cutting wheels and similar accesso ries must
be replaced frequently. The mandrel is a per -
manent shank, allowing you to replace only
the worn head when necessary, thus saving
the expense of replacing the shaft each time.
Screw Mandrel No 401
This is a screw mandrel used with the felt
polishing tip and felt polishing wheels. 1/8"
shank.
Small Screw Mandrel No 402
This is a mandrel with a small screw at its tip,
and is used with emery and fiberglass cutting
wheels, sanding discs and polishing wheels.
1/8" shank.
Dremel Accessories
Use only Dremel
, high-performance accessories. Other accessories are
®
not designed for this tool and may lead to personal injury or property damage.
EZ Lock Mandrel No 402
The Dremel EZ Lock makes accessory
changes easy as PULL - TWIST - RELEASE.
The one-piece mandrel design simplifies the
process of changing cutting wheels, buffs
and detail abrasive brushes (EZ Lock
compatible accessories).
EZ Drum™ Mandrel No EZ407SA
The Dremel EZ Drum makes accessory
changes easy as PULL - INSERT - PRESS
DOWN. The one-piece mandrel design
simplifies the process of changing sanding
bands.
High Speed Cutters
Available in many shapes, high speed cutters
are used in carving, cutting and slotting in
wood, plastics and soft metals such as
aluminum, copper and brass. These are the
accessories to use for freehand routing or
carving in wood or plastic, and for precision
cutting. Made of high quality steel. 1/8"
shank.
Tungsten Carbide Cutters
These are tough, long-lived cutters for use
on hard ened steel, fired ceramics and other
very hard ma terials. They can be used for
engraving on tools and garden equipment.
1/8" shanks.
19

Publicidad

Tabla de contenido
loading

Tabla de contenido