Bosch HEI80 Instrucciones De Instalación página 16

Ocultar thumbs Ver también para HEI80:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. Measure back left corner of range to bottom of cooktop
trim (B). Adjust leveling leg until this height is the same
as the corner dimension.
5. Repeat in right back corner.
6. Adjust front leveling legs so that the bottom of the
cooktop trim is ½" (12.7 mm) higher than the
corresponding countertop surface.
Slide Range into Opening
NOTICE
To avoid risk of damage to the range oven door, do
not lift, push or pull the range by holding the door
handle. Open the door and reach inside the top of
the oven cavity to locate a ridged area near the front
of the oven. Take care not to touch the oven heating
element also located at the top of the oven cavity,
just behind the ridged area.
1. Plug in power cord.
2. Dampen countertop and floor at bottom of opening with
soapy water.
3. Slide range into opening, being careful not to damage
countertops, floors, or the range door or warming
drawer front. Do not apply pressure to cooktop when
sliding into position. Be careful not to crimp the flexible
electrical connector.
English 13
Tip: Remove the range warming drawer to prevent
damage.
Check Back of range for proper Installation
1. When properly installed, the cooktop trim around the
back of the range will rest lightly on the countertop.
2. There should not be any gap between the countertop
and the trim; however, the weight of the range must not
rest on the countertop. Look under the range to verify
that both back legs are resting solidly on the floor. Also
verify that the left range leg is retained by the anti-tip
bracket.
Reinstalling the Oven Door
and Warming Drawer
Reinstall the oven door:
Reinstall the Warming Drawer.
1. Be sure cabinet rails are pushed inside cabinet.
2. Align the rails on the drawer rails with the rails attached
to the drawer housing.
1. Hold the door firmly in
both hands.
2. Hold the door at a 30º
angle from the closed
position and insert
hinges into the slots.
You may need to rock
the door forward and
backward slightly to
seat the hinge feet.
3. The door may need to
be removed and re-
inserted until the
hinges sit correctly in
the slots.
4. Open door all the way
to expose hinges,
levers, and slots.
5. Push levers forward
and down until seated
on the bracket.
6. Close and open door
slowly to be sure it is
correctly and securely
in place. Door must be
straight, not crooked.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Heip0Hiip0

Tabla de contenido