Makita DUR368A Manual De Instrucciones página 12

Hex wrench storage
CAUTION:
Be careful not to leave the hex
wrench inserted in the tool head. It may cause
injury and/or damage to the tool.
When not in use, store the hex wrench as illustrated to
keep it from being lost.
1
► 1. Hex wrench
For the loop handle model, the hex wrench can also be
stored on the handle as illustrated.
► 1. Hex wrench
Correct combination of the cutting
tool and the protector
CAUTION:
Always use the correct combi-
nation of cutting tool and the protector. A wrong
combination may not protect you from the cutting tool,
flying debris, and stones. It can also affect the bal-
ance of the tool and result in an injury.
Cutting tool
Nylon cutting head
1
Protector
12 ENGLISH
Installing the protector
WARNING:
Never use the tool without the
guard illustrated in place. Failure to do so can
cause serious personal injury.
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
Attach the protector to the clamp using bolts.
2
► 1. Clamp 2. Protector 3. Cutter
Installing the cutting tool
CAUTION:
Always use the supplied
wrench(es) to remove or to install the cutting tool.
CAUTION:
Be sure to remove the hex wrench
inserted into the tool head after installing the cutting tool.
NOTE: The type of the cutting tool(s) supplied as the standard
accessory varies depending on the countires. The cutting tool
is not included in some specifications of the model.
NOTE: Turn the tool upside down so that you can
replace the cutting tool easily.
NOTICE:
Be sure to use genuine Makita nylon
cutting head.
6
5
2
3
► 1. Nylon cutting head 2. Receive washer 3. Spindle
4. Hex wrench 5. Tighten 6. Loosen
1. Insert the hex wrench through the hole in the tool
head to lock the shaft. Rotate the shaft until the hex
wrench is fully inserted.
1
3
1
4