Switching On And Off - Bosch GLM 40 Instrucciones De Funcionamiento

Avoid heavy impact or falling of the tool. After heavy exterior
impact on the tool, an accuracy check should always be carried
out before continuing to work (see "Accuracy Check of the
Distance Measurement", page 17) each time before continuing
to work.
!
WARNING
beam yourself, not even from a large distance.
Do not leave the switched on measuring tool unattended and
switch the tool off after use. Other persons could be blinded
by the laser beam.
– To switch on the measuring tool and the laser, press the
measuring button 2 or the Clear/ On/Off button 5.
To switch off the measuring tool, press and hold the Clear/ On/
Off button 5.
Measuring Procedure (see figure A)
Once switched on, the measuring tool is in the real time
measurement function. Laser is automatically activated and tool is
measuring. You can set other measuring functions by repeatedly
pressing button 4 (see "Measuring Functions", page 12).
The rear edge of the measuring tool is always the reference point
for the measurement.
Place the measuring tool against the desired starting point of the
measurement (e.g. a wall).
Note: The measured value typically appears within 0.5 seconds
and no later than 4 seconds. The duration of the measurement
depends on the distance, the lighting conditions and the
reflective properties of the target surface. Upon completion of the
measurement the laser beam is automatically switched off.
Do not point the laser beam at persons or
animals and do not look into the laser

Switching On and Off

-11-