Stihl MS 261 Manual De Instrucciones página 28

English
2
Screw the nut (2) on to the stud as
N
far as stop by hand.
Releasing the chain brake
Pull the hand guarad towards the
N
front handle until there is an audible
click – the chain brake is
disengaged.
26
Fitting the chain
1
Wear work gloves to protect your
hands from the sharp cutters.
Fit the chain – start at the bar nose.
N
Pay attention to the position of the
tensioning gear and the cutting
edges.
Turn the tensioning gear (1)
N
clockwise as far as stop.
Turn the guide bar so that the
N
tensioning gear is facing you.
3
2
Fit the chain over the sprocket (2).
N
Fit guide bar in position – the collar
N
screw (3) engages the hole in the
tensioning gear. The heads of the
two short collar screws locate in the
guide bar slot.
Make sure the drive link tangs
N
engage the bar groove (see arrow)
and then rotate the tensioning gear
counterclockwise as far as stop.
Fit the chain sprocket cover so that
N
the wingnut locates on the collar
screw (3).
MS 261, MS 261 C
3