Assembly; Fitting The Loop Handle; Fitting The Trimmer Guard And Trimmer Head; Assembling And Dismantling The Two-Piece Shaft - Husqvarna 122C Manual De Instrucciones

Ocultar thumbs Ver también para 122C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fitting the loop handle

Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
Fit the bolt, securing plate and wing nut as shown in
the diagram. Tighten the wing nut.
Fitting the trimmer guard and
trimmer head
Fit the guard as shown in the diagram. Tighten
securely.
Fit the dust cup on the shaft. The nut must be
completely covered by the dust cup.
10 – English

ASSEMBLY

Hold the dust cup with a spanner to prevent the shaft
from rotating.
Screw the trimmer head onto the shaft.
Assembling and dismantling the
two-piece shaft (122LDx)
Assembly:
Loosen the coupling by turning the knob.
Align the tab of the attachment (A) with the arrow on
the coupling (B).
B
Push the attachment into the coupling until the
attachment snaps into place.
Before using the unit, tighten the knob securely.
A

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

122ldx122ldx serie

Tabla de contenido