Initial Settings; Adjusting Initial Settings; Setting The Clock; Turning The Clock Display On Or Off - Pioneer SUPER TUNER III D DEH-3850MP Operación Manual

Initial Settings

Adjusting initial settings

1
Using the initial settings, you can customize
various system settings to achieve optimal per-
formance from this unit.
1 Function display
Shows the function status.
1 Press SOURCE and hold until the unit
turns off.
2 Press SOURCE and hold until the clock
appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
ClockFM (FM tuning step)AM (AM tuning
step)R-SP (rear output and subwoofer con-
troller)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down SOURCE until the unit turns off.

Setting the clock

Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap-
pears in the display.
All manuals and user guides at all-guides.com
2
the clock display you wish to set.
Pressing c or d will select one segment of the
clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3
Pressing a will increase the selected hour or
minute. Pressing b will decrease the selected
hour or minute.

Turning the clock display on or off

You can turn the clock display on or off.
% Press CLOCK to turn the clock display
on or off.
Each press of CLOCK turns the clock display
on or off.
# The clock display disappears temporarily
when you perform other operations, but the clock
display appears again after 25 seconds.
Even when the sources are off, the clock display
appears on the display. Pressing CLOCK turns
the clock display on or off.

Setting the FM tuning step

The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1
Press FUNCTION repeatedly until FM appears
in the display.
Press c or d to select the segment of
Press a or b to set the clock.
Note
Press FUNCTION to select FM.
Section
08
27
En