Ec Declaration Of Conformity - DeVilbiss FLG-P5 Manual De Instrucciones

Read and follow all instructions and Safety Precautions before using this
The FLG5 pressure feed Spraygun is fitted with a 1.4mm or 1.1mm Nozzle for use with common
coating materials. The FLG5 Spraygun is approved to ATEX regulations 94/9/EC, protection
level;
Important: These spray guns are suitable for use with solvent-based coating materials. The
design uses EPA compliant atomising (DeVilbiss Trans-Tech®) technology to reduce overspray
and improve coating efficiency. Nozzles and needles are manufactured in stainless steel. These
guns are not designed for use with highly corrosive and/or abrasive materials and if used with
such materials it must be expected that the need for cleaning and/or replacement of parts will
be increased. If there is any doubt regarding the suitability of a specific material contact your
local Distributor or Finishing Brands UK Limited direct.

EC Declaration of Conformity

We, Finishing Brands UK Limited, Ringwood Rd, Bournemouth, Dorset, BH11 9LH, UK, as
the Authorised Representative of the manufacturer of the Spray gun model FLG5, declare,
under our sole responsibility that the equipment to which this document relates is in conformity
with the following standards or other normative documents:
BS EN ISO 12100: 2010, BS EN 1953: 2013; and thereby conform to the protection
requirements of Council Directive 2006/42/EC relating to Machinery Safety Directive, and;
EN 13463-1:2009, council Directive 94/9/EC relating to Equipment and Protective
Systems intended for use in Potentially Explosive Atmospheres protection level II 2 GX.
This product also complies with the requirements of the EPA guidelines, PG6/34.
Transfer efficiency certificates are available on request.
Important
equipment
Description
II 2 G X. Suitable for use in Zones 1 and 2
D. Smith, Director of Sales (EMEA)
25th August 2016
2
© 2016 Carlisle Fluid Technologies, dba Finishing Brands UK Ltd.