Dyna-Glo DGP483SSP Manual De Instrucciones página 21

OPERATION INSTRUCTIONS
Lighting The Grill
Before first use:
Remove all hangings or plastic straps, if present. Before you cook on your new gas grill, it is important to
clean your grill with heat. To do this, operate the grill for approximately 15 minutes with the lid closed and
the control knob in the highest position. This will clean the internal parts by burning off any residue and
odor from the manufacturing process.
If the flame extinguishes accidentally during ignition or operation, immediately TURN OFF the
cylinder valve and then TURN OFF the control knob.
Do not lean over grill when lighting. Read instructions before lighting. Do not put pots on the
sear side burner. Using pots on the sear side burner will result in high carbon monoxide levels.
1. Check that the control knobs are in the
2. Open the tank valve fully by turning it
3. Open lid during the lighting process.
4. Depress and turn control knob
position, to the HIGH position. You may need to repeat several times to ignite the burner.
If ignition does not occur in 5 seconds, turn the control knob(s) to
repeat the lighting procedure.
If the burner still does not light, check that there is gas in the cylinder and follow the match lighting
instructions. Check the Troubleshooting Guide on page 26 for more information.
CAUTION
WARNING
O
OFF position.
counter-clockwise.
counter-clockwise from the
21
O
OFF position, past the
O
OFF position, wait 5 minutes, and
ignite