English
Application
Access camera module 130° or 180°
for installation in Siedle Vario 611
and the Siedle Access intercom
system.
Electrical voltage
Mounting, installation and servicing
work on electrical devices may only
be performed by a suitably qualified
electrician.
• In the case of video systems, the
following mounting situation must
be avoided at all costs:
• direct ajour light
• direct sunlight
• very bright image backgrounds
• highly reflective walls opposite the
camera
• lamps or direct light sources
Scope of supply
• Camera module ACM 65x-...
• Terminal block
• This product information
Mounting
1 Recommended mounting height
appr. 1.60 m to centre camera.
For information on mounting the
camera module, see the "Vario
mounting instructions" enclosed
with mounting frame MR 611‑...
2 Note the mounting position of the
camera, the type designation must
be legible at the top back of the
module.
3 Pick-up angle of the camera
module ACM 673-...
4 Pick-up angle of the camera
module ACM 678-... in full screen
mode.
5 The pick-up angle of camera
module ACM 678-... can be
adjusted depending on the
mounting situation. Open the flap
on the back of the module with the
aid of a screwdriver.
6 Set the required picture excerpt
(1 to 9) or full screen (0) using the
rotary switch. Once the required pic-
ture excerpt has been set, close the
flap and mount the module.
7 Select the picture excerpt based
on the existing mounting situation.
a Picture excerpt (1-3) top camera
alignment
b Picture excerpt (4-6) central
camera alignment
c Picture excerpt (7-9) bottom
camera alignment
Terminal assignment
V1
video signal
V2
(two-wire FBAS)
V3
camera supply
V4
V5
Actuation of video output
V6
Pilfer safeguard
In order to protect the Vario modules
from unauthorized access, the pilfer
safeguard controller DSC 602-... can
be optionally used in conjunction
with the ZDS 601-... This can be
used to protect the inserted modules
from unauthorized access.
Installation
Installation and commissioning
are described in the Access system
manual.
Specifications
ACM 673-0
Colour system: PAL
Image pick-up: CMOS sensor 1/3"
728 x 488 pixel (horizontal/vertical)
Lens attachment: 2.1 mm
Aperture angle: horizontal appr.
130°, vertical appr. 100° (due to the
wide-angle lens, straight edges in
the peripheral areas of the picture
appear curved)
Resolution: horizontal 520 TV-lines
Integrated lighting: infrared
2-stage heating: max. 100 mA
Protection system: IP 54, IK 10
Ambient temperature:
–20 °C to +55 °C
Height of structure (mm): 15
Dimensions (mm) W x H x D:
99 x 99 x 41
ACM 678-0
Colour system: PAL
Image pick-up: CMOS sensor 1/3"
1280 x 960 pixel (horizontal/vertical)
Lens attachment: 1.4 mm
Aperture angle: horizontal appr.
170°, vertical appr. 135° (due to the
wide-angle lens, straight edges in
the peripheral areas of the picture
appear curved)
Resolution: horizontal 600 TV-lines
Integrated lighting: infrared
2-stage heating: max. 100 mA
Protection system: IP 54, IK 10
Ambient temperature:
–20 °C to +55 °C
Height of structure (mm): 15
Dimensions (mm) W x H x D:
99 x 99 x 41
5