X-Fir Filter (Finite Impulse Response) - LD Systems LDDSP44K Manual De Usuario

X-FIR FILTER (FINITE IMPULSE RESPONSE)

9.9
9.10
9.11
9.9 WINDOW TYPE - Collapsible menu to select the window type (custom = import a coefficient list)
FILTER - Selection window for bypass and filter types low pass, high pass or bandpass.
9.10
9.11 FREQUENCY - Lower or upper crossover frequency (lower and upper crossover frequency for bandpass). Entry field(s) for input via keyboard.
OUTPUT GAIN
9.14
9.12
9.15
9.16
9.13
9.18
9.17
9.12
- Click on the arrow icon (up arrow) to increase or decrease (down arrow) the gain by 0.1 dB.
9.12
Virtual Fader - Click and hold the Virtual Fader button and move it upwards to increase the gain and downwards to decrease it.
9.13
9.14 dB Display / Input Field - Displays the gain in dB and allows direct input via keyboard.
Polarity - Click this button to invert the polarity of the signal and then set it back to normal polarity (orange button for inverted polarity).
9.15
9.16 Mute - Click this button to mute the signal and then unmute it (red button for muted signal).
Signal Level Display
9.17
9.18 Display field for gain reduction (limiter)
9.19 - Click on the arrow icon to increase or reduce the signal delay of the corresponding channel.
Virtual Fader - Click and hold the Virtual Fader button and move it upwards to increase the signal delay and downwards to decrease it.
9.20
9.21 Display / Input Fields - Displays the signal delay in centimeters (cm), inches (inches), and milliseconds (ms), and allows
direct input via keyboard.
OUTPUT DELAY
9.19
9.21
9.20
9.19
13