Preferences - LD Systems LDDSP44K Manual De Usuario

Close the Ethernet Config window and then click on the magnifying glass symbol with a plus sign (Fig. 3.1) under Devices. The connected
power amp will now be displayed under Amplifiers with the model number, name, and serial number of the amplifier (Fig 3.2). Now double
click on the power amp model to synchronize the entire library stored to the power amp with the software (Fig 3.3.). The synchronization
process will take several seconds. If group parameters are enabled, a subsequent window will ask whether the group parameters are to be
sent from the OCS to the power amp ("Do you want to synchronize them?").
Generally, this request should be confirmed with "Yes" (click on "Yes"). You can find more information on control groups and their functions
in Section 11. CONTROL GROUPS of these instructions.

5. PREFERENCES

Project - Preferences - Click on the button Preferences (no. 5.1) to enter general settings like relative humidity and ambient temperature
(to determine delay) and to specify the minimum and maximum value in the Frequency Response window, to enable Unwrapped phase
range, and to switch the phase threshold from Auto to Full Band and vice versa. Click on Restore default values to restore these settings
to the factory default settings the next time the software starts. These settings are stored when saving a project file.
6
4.3
5.1