Control Groups - LD Systems LDDSP44K Manual De Usuario

11. CONTROL GROUPS

The control groups make it possible to freely group and simultaneously manage the input gain and input delay of the desired channels for
the power amps connected to the computer via Ethernet. The control of the input gain and the input delay in these groups is relative to the
settings in the input channels of the corresponding power amplifiers, meaning the gain and delay of the control group and input channel are
added together and the result is displayed as a total value (Total).
The corresponding power amps must be recognized by the system in order to create gain and delay groups as needed. Now click on the
Control Groups button (no. 11.1). This will open the group window. Click once on Groups (no. 11.2) and then add the gain groups and delay
groups as desired by clicking the Add Gain Group (no. 11.3) and Add Delay Group buttons (11.4) on the menu bar. Name the groups as
desired and click on OK. Add a power amp for a gain group and/or delay group via drag and drop. Now the Assign to Control Group window
will open, where you can name the gain or delay group (Control Group Name, no. 11.5), select to which of the 4 power amp channels the group
is to be assigned (assignment, no. 11.6), and click on Add To Group (no. 11.7). Mark the group you would like to edit (click 1x), and click on
Open Group (no. 11.8) on the menu bar. You can apply your desired settings to the windows that will open (no. 11.9 and 11.10). Groups can be
renamed or deleted by clicking on the desired group and then clicking the corresponding button (Rename Group no. 11.11 and Delete Group no.
11.12). Groups can be collected in folders by clicking on Groups (no. 11.2), then clicking on Add Folder (no. 11.13) and dragging and dropping
the desired control groups to the folder (Rename and delete folder via Rename Folder no. 11.14 and Delete Folder no. 11.15). To save the
control groups and device settings to a file, click on Project (no. 11.16) and then Save Project (no. 11.17). Name the file as desired and save it
to your computer. The speaker and amp presets used in the project will not be saved with the project file; they must therefore be loaded to the
DSP44 or DSP45 used. Open a project by clicking on Open Project (no. 11.18), create a new project by clicking on New Project (no. 11.19),
and save the current project under a new name by clicking on Save Project As (no. 11.20).
11.1
11.16
11.8 11.11 11.12 11.13 11.14 11.15 11.19 11.18 11.17 11.20
11.3 11.4
23