Creating Connection Via Ethernet - LD Systems LDDSP44K Manual De Usuario

4. CREATING CONNECTION VIA ETHERNET

Connect the Ethernet port on the LD DSP44K or DSP45K power amp using a suitable Ethernet cable with the Ethernet port on your PC, and
switch on the power amp. If you would like to connect and manage 2 or more LD DSP44K or DSP45K power amps with your PC, please use
an Ethernet switch and set a unique IP address for each power amp (e.g. 192.168.0.100, 192.168.0.101, etc.). You can manually set the IP
address of the power amp on the device itself or in the OCS software under Ethernet Config. The IP address of the LD DSP44K or DSP45K
power amp is set to 192.168.0.100 by the manufacturer, meaning another IP address must be used in the PC system settings under Inter-
net Protocol Properties Version 4 (TCP/IPv4), in this case, 192.168.0.1 (Fig. 4.1), for example. IP settings can be automatically
applied (Fig. 4.2), if the network supports this function (e.g. network route). Start the OCS software and ensure that DHCP is enabled under
Ethernet Config (DHCP Enabled, Fig. 4.3), also click the button for Use DHCP and the button Update IP/DHCP. In addition, you can search
for a device in the Ethernet Config window
(Search Devices), change the IP address of a power amp (if DHCP is not used, enter numbers into the input field and click Update IP/
DHCP), reset the Ethernet module of the power amp (Reset Ethernet Module), and assign a name to the power amp
(enter name into the input field under "Device Name" and click Change Device Name). To identify a power amp, click on the desired
power amp in the device list, then click on Identify Device, the power amp name and IP address will be shown on the device display for a
short time.
Note: In certain cases, there may be a conflict between the Ethernet interface and the WLAN interface, resulting in the OCS software not
being able to detect the Ethernet interface. In this case, disable the WLAN interface on your computer.
4.1
4.2
5