Frequency Response - LD Systems LDDSP44K Manual De Usuario

GAIN
10.20 - Click on the arrow icon to increase or decrease the gain of the chosen EQ band in 0.1 dB intervals.
Virtual Fader - Click and hold the Virtual Fader button and move it upwards or downwards to set the gain
10.21
as desired.
dB Display / Input Field - Displays the gain in dB and allows direct input via keyboard.
10.22
10.23 LINK - Before editing, you can link the channels whose settings are to be the same (check the box).
The settings must therefore only be applied to one channel and will be automatically applied to linked channels.
10.24 FILTER NUMBER - Displays the filter number and allows selection of filters 1 to 12 using the arrow icons (selected band is hig
lighted in white).
10.25 FILTER TYPE - The filter type of the filter in channels 1 to 4 cannot be selected and is therefore grayed out
(Filter 1 = low shelf, Filter 2 - 11 = parametric, Filter 12 = high shelf).
10.26 FILTER ON - Check the box on the control panel to activate the chosen filter, deactivate the filter by unchecking the box (bypass).
Save - Use this button to save the filter settings of each 12 EQ band as an EQ preset file to your PC.
10.27
10.28 Open - Load a previously saved EQ preset from the PC to the selected channel 1 to 4.
CHANNEL 1 to 4 - Select the desired channel for editing by clicking on the channel button.
10.29
EQ 1 to 12 - Overview window for EQs 1 to 12. Enable or disable the desired EQ bands using the mouse (checking ON = EQ band
10.30
enabled, unchecking = EQ band disabled).
FREQUENCY RESPONSE (NOT SIGNED IN AS ADMINISTRATOR)
10.36
10.35
10.34
10.34
10.31 Frequency Response - Graphic depiction of the frequency response. (Zooming in horizontally: Mark the desired area by
dragging the mouse cursor to the right. Zooming out horizontally: Mark the area by dragging the mouse cursor to the left.
Push vertically with Ctrl and left mouse button).
Note: In order to determine yourself which channel the cursor will follow when moving over the graphic (9.88), please
log in to the OCS software as administrator (6.9).
GAIN and FREQUENCY grip point - Click and hold this grip point to change the frequency and gain of the chosen
10.32
frequency band by moving it horizontally and vertically.
Grip point FILTER QUALITY Q - Click and hold a grip point to change the filter quality of the
10.33
chosen frequency band by dragging horizontally as desired.
Max. / Min. - Zoom in vertically using the arrow icons.
10.34
10.35 Disable GAIN - Click on this button to suspend editing of the gain on the graphical window (red button)
or to again allow editing (gray button).
10.36 Disable FREQ - Click on this button to suspend editing of the frequency on the graphical window (red button)
or to again allow editing (gray button).
10.33 10.32
10.31
10.33
21