Symbols In The Operator's Manual - Husqvarna 357XP Manual De Instrucciones

Symbols in the operator's
manual:
Switch off the engine by moving the
stop switch to the STOP position
before carrying out any checks or
maintenance.
Always wear approved protective
gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must
be worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake must be engaged
when the chain saw is started.
WARNING! Kickback may occur
when the nose or tip of the guide bar
touches an object, and cause a lightning
fast reverse reaction, kicking the guide
bar up and towards the operator. May
cause serious personal injury.
KEY TO SYMBOLS
You will find the following labels on your chain saw:
EPA III
The Emissions Compliance Period referred to on the
Emission Compliance label indicates the number of
operating hours for which the engine has been shown to
meet Federal emissions requirements. Category C = 50
hours, B = 125 hours, and A = 300 hours.
Maintenance, replacement, or repair of the emission
control devices and system may be performed by any
nonroad engine repair establishment or individual.
The engine exhaust from this product
contains chemicals known to the State
defects or other reproductive harm.
of California to cause cancer, birth
–
English 3