Kobalt VT6362 Manual De Instrucciones página 13

INSTALLATION INSTRUCTIONS
4. Remove ground screw. Install strain relief on pressure switch. DO NOT tighten strain relief on
power cord until wiring is complete. Insert the bare wires (black, white, bare/green) through the
strain relief.
Attach bare/green ground wire fi rst to ground screw on pressure switch body.
Look for the "Line" markings on pressure switch. Install Line wires and tighten terminal screws.
5
5. Tighten strain relief nut. Place a fl athead screwdriver (not included) into raised notch and tap
screwdriver with hammer (not included) until tight.
Tighten strain relief screws to hold power cord securely. Replace the pressure switch cover (knob
must be in the same position as when removed to sit correctly in place). Tighten the pressure
switch screw with Phillips screwdriver. Check that switch is in the OFF position. Follow break-in
procedure starting on page 16.
6
Terminal Screw
Black Line
Wire
Power Cord
Strain Relief
13
White Line Wire
Bare/green
Ground Wire
Strain Relief Nut
Strain Relief Screw
kobalttools.com