Installation; Preparation; Mounting The Legs - Dovre TAI 35W Instrucciones De Instalacion Y Uso

Installation

Preparation

Please check the appliance for damage caused dur-
ing transport or any damage or defects immediately
after delivery.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the removable parts (fire-resistant inner
plates, fire compartment, fire basket, ash removal
port and ash pan) from the appliance before you
start installing the appliance.
By removing removable parts, it is easier to
move the appliance and to avoid damage.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
1. Open the door; see the following figure:
2. Remove the fire-resistant inner plates; see the fol-
lowing figure:
Subject to change because of technical improvements
a. Remove the fire basket (5).
b. Raise the baffle plate (1) at the front, pull the
c. Remove the inner plates on the left and right
d. Remove the inner plates on the back (2).
1
2
3
4
5
6
7
Removable internal parts
1 baffle plate
2 back inner plate left and right
3 side inner plate left and right
4 ash removal port
5 fire basket
6 fire compartment base
7 ash pan
09-20020-368

Mounting the legs

The appliance is supplied without fitted legs. The
stove is mounted on a pallet (3); see following figure.
baffle plate 2 cm forwards and allow the baffle
plate to drop down at the back
sides (3).
Vermiculite inner plates are light and tend
to be ochrous in colour on delivery. They
insulate the combustion chamber to boost
combustion.
2
3
09-20020-369
9