Start Up - Truper CALA-A3 Instructivo

Start Up

Start Up and Operation Control
• Intermittent Operation:
Connect the plug into the outlet.
Press switch (A) to start the Jigsaw.
To stop the tool, simply release the switch.
• Continuous Operation:
Connect the plug into the outlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop the tool, press and release the switch.
Swinging Action Control
Swinging action varies the blade cutting angle to increase the
cutting efficiency.
It shall be adjusted with the Jigsaw unloaded. Do not apply
excessive force on the blade when cutting with the swinging
action. The blade cuts only upwards.
Thin materials. Fine Thick materials (steel
Cuts, Sharp Corners and chipboard)
(steel and wood).
Speed control
• The tool can operate at different speeds. You can select the speed
by adjusting the speed control into the tool upper side.
• Adjust speed with the speed control according to the material, its
width and the blade specification (it is possible to do this when
running without load). See the speed guide to select the right speed
for the job.
• Avoid running at low speed for long periods. The
WARNING
motor might be damaged.
Adjusting the Cutting Angle
• Disconnect the unit from the power source.
• Loosen the 2 screws on the base plate with the
Allen key included.
• When the screws are loosened, adjust the base
plate into the desired angle using the serrated
guide in the base plate.
• Tighten the screws back.
• Set the Allen key back in its holder in the power
cable protector immediately after use.
Particle Vacuuming
Connect the dust collector to the Jigsaw through the vacuum
cleaner vacuum cleaner connection to collect the dust.
Vacuum clean dust, sawdust or any particle from the work
surface.
Thick material (wood) Fast cuts (soft wood)
Cutting along the
wood grain.
A
Swinging
Action Control
Speed
Speed guide
control
Material
Rubber
Aluminum
Steel
Wood
Collector
B
Speed
1-2
3-4
4-5
5
Dust
7
ENGLISH