Start Up - Truper SCI-10 Manual De Instrucciones

Miter Guide
• The miter guide can be adjusted to ±60° depending on
the job to be carried out.
• Loosen the miter guide knob (A) to adjust the angle.
• Once the miter guide has the desired angle signaled by
the pointer (B) tighten the knob firmly.
B
Turning On
• Before connecting the saw to the power source, check the
connection according to the supply voltage (120 V~/ 220 V~).
(See page 12).
• The saw is built with a safety key switch to prevent
unauthorized use. If leaving idle the machine for long periods
of time and there is a possibility that other people could use it,
especially children remove the safety key with the switch in the
off position (O). Keep it in a safe place, do not lose it because
the saw could not be used again.
• To turn on the saw, insert the safety key and lift the switch
into the on position (I).
• To turn off the saw, lower the switch into the off position (O).
WARNING
• Double check the switch is in the off
position (O) before connecting the saw to the power source.
Operation
• Be aware the band runs in a continuous descending run.
• Using both hands hold the work piece firmly onto the
table and feed slowly towards the band, keeping your
hands away from the band.
• To get better results the band shall be honed. A dull band with not cut right, especially in straight cuts and will cause
excessive pressure on the rear guide bearings.
• Select the right band for the job, depending on the wood thickness and type of cut to be made. The thinner and hard the
wood, the finer the band teeth shall be. Use a fine tooted band for steep curved cuts.
• The machine is especially designed to make curved and straight cuts.
• When cutting follow the design marked by only pushing and turning the work piece in a uniform manner.
• Do not try to turn the piece by pushing it. It could cause the work piece will get stuck or the band will bend.
• For straight cuts, use the support fence to slowly feed the work piece towards the band and in contact with the fence.
10
ENGLISH
A
Adjustments
Support Fence
• The support fence can move over to get close or far away
from the cutting band depending on the job.
• To release the fence, lift the lever (C) and set it into the
desired position. Lower the handle to assure the fence is in
place.
C

Start Up

Safety
Key
I
ON
O
OFF