Start Up; Installing The Blade - Truper SISA-N2 Manual De Instrucciones

Start up

Installing the blade

• Disconnect the plug from the power source.
• Loosen the blocking lever and slide the pivot type shoe
outwards (1).
• Turn the blade chuck clockwise (2).
• Insert the blade in the chuck slot (3).
• Turn the blade chuck into its original position (4). Pull the
blade to double-check it is correctly fixed.
• To remove the blade turn back the blades chuck
clockwise and pull out the blade.
The blade is designed to use all blades with a 1/2"
universal shank.
Pivot type shoe adjust
The pivot type shoe allows adjusting cutting depth by
sliding the saw blade outwards or inwards. It also keeps a
constant distance in the work piece while is being cut to
provide the best control, to increase the work life of the
blades and reduce malformation beyond the end of the
pivot type shoe when cutting large surfaces.
WARNING DO NOT operate the saw if the pivot
type shoe is not properly fixed. Otherwise the swinging
mechanism could hit the work piece and damage the saw.
It can cause no control and severely injuring the operator.
• Disconnect the plug from the power source.
• Loosen the shoe extension-blocking lever turning it
towards the arrow (A).
• Adjust the pivot type shoe into the desired extension (B).
• Return the shoe extension-blocking lever to its original
position (C), NEVER operate the saw if the shoe-blocking
lever is correctly fastened. Otherwise the operator will
loose stability and might suffer a severe accident.
• Turn the shoe base depending on the cutting angle
regarding the work piece surface (D).
• Connect the saw and slowly press the switch to confirm
the blade tip is ALWAYS extending further than the pivot
type shoe and the work piece while swinging to prevent
the blade is damaged (E).
2
1
3
B
D
E
4
A
C
7
ENGLISH