Assembly Instructions - Kobalt SGY-AIR228 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Remove plastic air inlet protective cap
from air inlet (E) (See Figure 1).
NOTE: The air inlet (E) will spin freely, so
two wrenches are required to inert the
male plug.
2. Insert the male plug into the air inlet (E).
Using a 3/4 in. (19 mm)
wrench (not included) hold the air inlet
nut (E), and tighten the male plug by
turning it clockwise using a 9/16 in.
(14 mm) wrench (not included)
for an air tight connection.
DO NOT OVERTIGHTEN.
NOTE: Use threaded sealant tape
(not included) on the threading of the
male plug.
3. Place 2 – 3 drops of air tool oil
(not included) into the opening of the
male air plug before each use
(See Figure 3).
1
2
3
10
E
E