Assembly Instructions - Kobalt SGY-AIR185 Manual Del Usuario

ASSEMBLY INSTRUCTIONS

1. Remove plastic air inlet protective cap
from air inlet (E).
2. Prepare a 1/4-in. male plug by applying
sealant tape (not included) to the
threading, wrapping clockwise. Screw
threaded male air plug by hand into air
inlet (E), then tighten with a wrench
(not included) for an airtight connection.
DO NOT OVERTIGHTEN.
Sealant tape must be used on this
NOTE
connection.
3. Select the correct impact socket
(not included) for the threaded fastener to
be tightened or loosened and mount it onto
the anvil (B) until it clicks into place.
Use only adapters and sockets with a torque
rating equal to or greater than the tool itself.
Always make sure adapters and sockets are
properly mounted and secure before using
the tool. Loose attachments can break or fly
off, causing serious injury to the operator or
bystanders in the work area. Always follow
all manufacturers' specifications for proper
attachment and use.
All manuals and user guides at all-guides.com
WARNING
1
2
3
11
B
kobalttools.com