Superwinch EX1 Manual Del Propietário página 7

Circuit
Protector
Figure 10
If connection to the battery positive
terminal is not possible because of
the terminal design, connect the
circuit protector to the starter
solenoid "hot" side. Determine the
"hot" side by tracing the battery
cable to the solenoid connection.
Connect the red supply wire to the
same terminal to which the battery
cable is connected (Figure 10).
Note: Special adapters are available
from your local Auto Parts Dealers
for making connections to Side Post
Batteries.
The switch and motor end are
designed so the switch will mount
properly only when installed as
shown in Figure 11. Do not attempt
to install the switch in the opposite
direction. If the switch is installed
incorrectly and electrical contact
made, the winch will run in a direc-
tion opposite that is indicated on
the product label resulting in possi-
ble operator injury.
Figure 11
Circuit
Protector
Battery
Cable
Switch
Wires
From Switch
Red
Secure the switch to the motor by
tightening the round thumb screw
on the outside of the switch (Figure
12). The screw threads into the
tapped hole between the brass
motor contact (Figure 11). Do not
use pliers or over-tighten the thumb
screw.
Figure 12
After the switch is in place, remove
excess slack from the wiring harness
in the vehicle by doubling over
slack areas and tying securely. Do
not leave any dangling or loose
wiring.
Solenoid
7