cecotec CONGA 3590 Manual De Instrucciones página 31

ENGLISH
Note:
After 12 hours of no operation, the robot will turn automatically off.
The robot will not enter standby mode during charging.
Suction power level
Press the suction power level function on the App to set the desired power level.
Choose between Eco (low power), Medium (medium power) and Turbo (high power).
Schedule
The robot is provided with a schedule function in order to provide a maximum-efficiency
cleaning. The time settings and the cleaning scheduling must be carried out from the App.
Once the robot has been scheduled, it will automatically carry out the cleaning cycles every
scheduled day.
Note: Make sure the robot is activated and that the light indicator is lighted before scheduling
any cleaning or setting time.
Light indicator:
Operating: Steady blue light
Low power: Orange light blinks slowly
Charging: Orange light oscillates
Network configuration: Blue light blinks slowly
Start-up/firmware update: Blue light oscillates
Error: Red light flashes quickly
Modes
The first time the robot is operated, it will map and save the whole house's map by means of its
laser before starting the cleaning cycle. Use the robot in Auto mode and Eco power level, this
way you will ensure the robot memorizes the full map.
Note: Make sure the light indicator is lighted in blue before starting cleaning, indicating it is
activated. If not, press any button on the App to activate it.
Auto mode
Fig. 14.
Press the Auto mode button on the App for it to start cleaning automatically, first a cleaning
cycle in Edge mode and then another cycle in and organized zigzag motion, recognizing which
areas it has cleaned and which ones it has not. The robot will automatically plan the cleaning
route as it is cleaning. If during this mode the robot is controlled manually, the robot will
calculate the route again and could go through previously cleaned areas. In order to ensure
efficient cleaning, do not operate it manually during auto mode cleaning.
30