DJI Snail Manual Del Usuario página 10

4. Install the unmarked propellers onto the red Propeller Adapter,
and install the propellers marked with CW onto the black
Propeller Adapter.
5. Secure the propellers by rotating the red cap onto the axes of
the red Propeller Adapter and black cap onto the axes of the
black Propeller Adapter.
Stand clear of the motors and DO NOT touch the propellers
when they are spinning.
Use only DJI approved propellers.
Use appropriate propellers for your needs, as they can wear out.
Pay attention to screws properly during installation and removal.
Before mounting 6048-3D Propellers, select 3D Mode in DJI
Assistant 2 and update the corresponding firmware. (Refer to
Using DJI Assistant 2 for details)
Using DJI Assistant 2
DJI Assistant 2 is used to update and configure the ESC.
Remove propellers before connecting to DJI Assistant 2.
430-R ESC
Unplug any other serial devices connected to your PC before
updating. Then follow the instructions below.
1. Download and install DJI Assistant 2 from the Official DJI
website. (http://www.dji.com/snail/info#downloads)
2. Connect the ESC Programmer to the ESC with the PWM
signal cable and to your computer using the USB cable on the
programmer.
3. Connect a battery (3-4S LiPo) to supply power to the ESC.
Do not disconnect the ESC from your computer or the power
supply until configuration is complete.
©
8
2017 DJI All Rights Reserved.
ESC Programmer PC