Stihl KM 90 R Manual De Instrucciones página 25

3
4
5
Ease the spring clip (3) off the
N
starter post.
Remove the rope rotor with
N
washer (4) and pawl (5).
Remove the remaining rope from
N
the rotor and starter grip.
KM 90 R
Tie a simple overhand knot in the
N
new rope and then thread it through
the top of the grip and the rope
bushing (6).
Thread the rope through the rotor
N
and secure it with a simple
overhand knot.
Coat the rope rotor bearing bore
N
with non-resinous oil.
Slip the rotor over the starter post –
N
turn it back and forth to engage the
anchor loop of the rewind spring.
6
Refit the pawl (5) in the rotor.
N
Fit the washer (4) on the starter
N
post.
Use a screwdriver or suitable pliers
N
to fit the spring clip (3) on the starter
post and over the pawl's peg – the
spring clip must point
counterclockwise – as shown in the
illustration.
Go to "Tensioning the Rewind
N
Spring".
Replacing a broken rewind spring
Remove the rope rotor as described
N
in chapter on "Replacing the starter
rope".
English
3
4
5
23