Publicidad
Step 13
1
D83
Groove
Insert the DRAWER SIDES (D83 and D84) at an angle
å
into the slot at each end of the DRAWER FRONT (K).
3
Fasten the DRAWER BACK (D67) to the DRAWER
å
SIDES (D83 and D84). Use four BLACK 1-9/16" FLAT
HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D703) inserts
å
into the groove of the DRAWER BACK (D67).
www.sauder.com/services
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D84
K
D67
D83
D703
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
i s h
r f a
c e
D83
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D703) into the grooves in the
å
DRAWER SIDES (D83 and D84) and DRAWER FRONT (K).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
(4 used in this step)
D84
408696
With the palm of
your hand, tap the
DRAWER BOTTOM
down into the groove.
e d
D703
D84
K
30S
Page 17
Publicidad
