Descargar Imprimir esta página

Differential Feed; Adjusting The Presser Foot Pressure - Brother 884-B01 Manual De Instrucciones

Ocultar thumbs Ver también para 884-B01:

Publicidad

Idiomas disponibles

Idiomas disponibles

Differential feed

This serger is equipped with two sets of feed dogs under
the presser foot to move the fabric through the machine.
The differential feed controls the movement of both the
front and the rear feed dogs. When set at 1, the feed
dogs are moving at the same speed (ratio of 1). When
the differential feed ratio is set at less than 1, the front
feed dogs move slower than the rear feed dogs,
stretching the fabric as it is sewn. This is effective on
lightweight fabric that may pucker. When the differential
feed ratio is set at greater than 1, the front feed dogs
move faster than the rear feed dogs, gathering the fabric
as it is sewn. This function assists in removing the
rippling when serging stretch fabrics.
Differential feed adjustment
Main
Differential
Feed
feed
feed
ratio
(rear)
(front)
0.7 - 1.0
1.0
1.0 - 2.0
The normal setting is 1.0 on the differential feed
adjustment dial.
To adjust the diffrerential feed, turn the dial on the right
bottom of the body.
<A>
2
1 Less than 1.0 2 Greater than 1.0
<A> Selection mark
Application
Effect
Prevents thin
Material is
materials from
pulled tight.
puckering
Without
Normal
differential
sewing
feed.
Prevents
Material is
stretch
gathered or
materials from
pushed
stretching or
together.
puckering
1
An example
When stretch material is sewn without using the
differential feed, the edge will be wavy.
To get smooth finish, adjust the feed ratio from 1.0
toward 2.0.
(The feed ratio required depends on the elasticity of the
material.)
The more elastic the material, the further toward 2.0 the
differential feed ratio should be set. Test sew with a
scrap of the fabric to find the correct adjustment.
CAUTION
When sewing thick non-stretchable material such
as denim, do not use the differential feed as it may
damage the fabric.

Adjusting the presser foot pressure

Turn the pressure adjustment screw on the top left of the
machine. You can adjust by reffering the value on the
screw.
The normal setting is "2".
1
<A>
1 Less pressure
2 More pressure
<A> Selection mark
2
7

Publicidad

Capítulos

loading