Accessories - RIDGID R41222 Manual Del Operador

MAINTENANCE
CLEANING THE LED LENS
See Figure 44.
Over time the LED light may become cloudy or dull. If this
occurs, the LED lens may require cleaning.
To clean the lens:
 Unplug the saw.
 Raise the saw arm.
 Remove the blade as described in the Assembly section.
 Rotate the lower blade guard to expose the LED lens.
 Using a small cloth or a cotton swab, gently clean away
any dirt or debris from the LED lens.
NOTE: Use caution when cleaning to avoid damaging
the lens.
 Reinstall the blade.

ACCESSORIES

Look for these accessories where you purchased this product or call 1-866-539-1710:
 AC9945 Miter Saw Utility Vehicle .......................................................................................................................987310001
 Dust Bag Assembly ............................................................................................................................................902981001
 12 in. Blade ........................................................................................................................................................681780001
 Zero Clearance Throat Plate ..............................................................................................................................525425001
 Work Clamp Assembly .......................................................................................................................................203154001
 Blade Wrench .....................................................................................................................................................693391002
WARNING:
Current attachments and accessories available for use with this product are listed above. Do not use any attachments
or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not
recommended can result in serious personal injury.
34 - English
LED
COTTON
LENS
SWAB
Fig. 44