Stihl MS 661 C-M Manual De Instrucciones página 39

Once the engine is running
1
2
Simultaneously blip the throttle
N
trigger lockout and the throttle
trigger (2); the Master Control
lever (1) jumps to run F and the
engine begins to idle
Pull the hand guard toward the
N
handlebar
The chain brake is released - the chain
saw is ready for use.
NOTICE
Open the throttle only when the chain
brake is off. Increased engine speeds
with the chain brake on (saw chain is
stationary) will quickly damage the
clutch and chain brake.
MS 661 C-M
At very low temperatures
if necessary, configure for winter
N
operation, see "Winter Operation"
0 Switching off the engine
Push the Master Control lever to
N
STOP or † – when the Master
Control lever is released, it returns
to the operating position F
If the engine does not start
Check if all operating elements are
N
set correctly
Check whether there is fuel in the
N
tank and refuel if necessary
Check whether the spark plug boot
N
is connected securely
Repeat the starting procedure
N
or:
there is possibly a non-combustible fuel-
air mixture in the combustion chamber of
the engine that is too rich– the engine
has flooded.
N
N
0
1
To reduce the risk of fire and burn injury,
never pull the starter cord or attempt to
restart the engine with the spark plug or
the spark plug boot removed. In the start
and operating positions, pulling the
starter rope will create sparks that can
ignite fuel and/or fumes.
The recommended procedure in
this situation is to let the machine sit
for an adequate amount of time to
allow the combustion chamber to to
clear and then restart the engine
As an alternative, after engaging the
chain brake, you can push in the
decompression valve and, while
holding the unit down with one knee
and keeping the throttle trigger fully
depressed, pull on the starter rope
several times until the engine starts
WARNING
English
37