Installation; Installing/Replacing The Lamp; Attachment - EuroLite Neon-Tube Complete Set Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION

Installing/Replacing the lamp

Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
During the installation do not touch the neon-tube bare-handed! Please follow the lamp manufacturer's
notes!
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the device
was not designed for. Damages caused by non-observance are not subject to warranty.
During the operation, the lamp reaches temperatures of up to 80° C.
Neon illuminants are hazardous waste which needs to be disposed of appropriately.
Please dispose of the unusable neon illuminants in accordance with the current legal regulations.
Procedure:
Step 1: Loosen the endcaps and pull them off.
Step 2: Carefully remove the luminaire cover and the neon tube.
Step 3: If replacing the neon-tube, remove the old lamp from the socket.
Step 4: Insert the new neon-tube into the lamp-socket and carefully turn the tube into place.
Step 5: Carefully replace the luminaire cover.
Step 6: Ease the endcaps back into position.

Attachment

Before attaching the device, make sure that the installation area can hold a minimum point load of 10 times
the device's weight.
The device must only be installed absolutely planar at a vibration-free, oscillation-free and fire-resistant
location. Make sure that the device is installed absolutely planar by using a water-level.
The device must be installed out of the reach of people.
The device must always be installed via all fixation holes. Do only use appropriate screws and make sure
that the screws are properly connected with the ground.
The durability of the installation depends very much on the material used at the installation area (building
material) such as wood, concrete, gas concrete, brick etc. This is why the fixing material must be chosen to
suit the wall material. Always ask a specialist for the correct plug/screw combination indicating the maximum
load and the building material.
DANGER TO LIFE!
Only install the lamp with the device switched off!
Unplug from mains before!
CAUTION!
The lamp has to be replaced when it is damaged
or deformed due to the heat!
11/23
00028684.DOC Version 1.1

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

51101469511014705110147151101472

Tabla de contenido