EMAK CROSSJET TUAREG 92 EVO Manual De Usuario página 21

3.4.6 PERFORMING A LEAK TEST ON THE HYDRAULIC CIRCUIT
Visually check the hydraulic circuit for oil leaks, namely the locations where fittings are connected to
the transmissions. If you discover any leaks, inform your service centre.
3.5 DRIVING THE MACHINE FROM THE PALLET
 Prepare two suitable ramps and place them next to the pallet so that the
machine's wheels can ride on to them. If you drive off the pallet without
ramps, there is a danger of damaging the underside of the machine,
particularly the mowing deck!
 Lift the mowing deck into the transport position by pulling on the mowing
deck elevation lever (
 Move the throttle lever from position
( 4.2.1 (5)).
 Pull out the choke lever (
 Set the by-pass lever to position "1" (
 Start up the machine by turning the key to position
slowly drive the machine down off the pallet.
Further details about starting up and stopping the engine are provided in
4.2.1 (10)).
4.2.1 (6)).
4.2.1 (11)).
21
approximately half way
( 4.2.1(1)) and
5.2 and 5.3.