Philips NORELCO S5660 Manual De Instrucciones página 27

22_002_7353_1_DFU-Booklet_A6_v6.indd 27
When the SmartClean System is ready for use,
do not move appliance to prevent leakage.
Cleaning the Shaver in the
SmartClean System
◗ If the shaver does not contain enough power
for one (1) shave, the SmartClean System
may not work properly. Charge the shaver
in the SmartClean System before using the
SmartClean System to clean your shaver.
◗ If you use the shaver with shaving foam or gel,
quickly rinse under hot water before cleaning
in the SmartClean System.
Connect the small plug to the SmartClean
1
System. Connect the power plug into any
100V to 240V AC outlet. Use only the
power cord provided.
2. Place the SmartClean System on a flat,
level surface. Make sure the seal has been
removed from the cleaning cartridge (see
'Preparing SmartClean System For Use').
C
3 Press the top cap down to open the
SmartClean System.
ENGLISH
27
06/06/17 16:14