Loudness Adjustment (Loud); Front Image Enhancer Function (Fie) - Pioneer Super Tuner III Manual Del Operador

4. Select the desired Q factor
with the 5/∞ buttons.
2N + = 1N + = 1W + = 2W
Note:
• If you make adjustments when a curve other than "CUSTOM" is selected, the newly adjusted curve
will replace the previous adjusted curve. Then a new curve with "CUSTOM" appears on the display
while selecting the equalizer curve. (Refer to page 27.)

Loudness Adjustment (LOUD)

The Loudness function compensates for deficiencies in the low and high sound ranges at
low volume. You can select a desired Loudness level.
1. Press the AUDIO button and select the Loudness mode (LOUD) in the Audio
Menu.
2. Switch the Loudness function
ON/OFF with the 5/∞ but-
tons.
3. Select the desired level with
the 2/3 buttons.
LOW + = MID + = HI
Note:
• You can also switch the Loudness function ON/OFF by pressing the LOUD button. However,
you cannot change the level.

Front Image Enhancer Function (FIE)

The F.I.E. (Front Image Enhancer) function is a simple method of enhancing front imaging
by cutting mid- and high-range frequency output from the rear speakers, limiting their out-
put to low-range frequencies. You can select the frequency you want to cut.
Precaution:
• When the F.I.E. function is deactivated, the rear speakers output sound of all frequencies, not
just bass sounds. Reduce the volume before disengaging F.I.E. to prevent a sudden increase in
volume.
" "
Continued overleaf.
30