Volume Control; Aux Mode - Lenco CR-530 Manual Del Usuario

3. Auto-searching: press and hold the [HOUR/SKIP-] button or [MIN/SKIP+] button can auto
adjust the FM stations
4. Memory obtain the stations: short press [CLOCK/MEM.] button to callout the pre-set
station, the display will show "P01", press [CLOCK/MEM.] button again can callout the next
pre-set station, also you can press [HOUR/SKIP-] button or [MIN/SKIP+] button select the
pre-set stations. The display will show station frequency 5 seconds later, will exit the time
display if not press any buttons for 5 seconds
5. Storage the stations: select the station which you need stored, press and hold
[CLOCK/MEM.] button for 2-3 seconds, "P01" on LED display will blinking, press
[HOUR/SKIP-] button or [MIN/SKIP+] button to select the stored position, press
[CLOCK/MEM.] button to confirm
AUTO POWER OFF (SLEEP MODE)
Under power on mode, press [SNOOZE/SLEEP] button, LED will show "10", you can
continued press [SNOOZE/SLEEP] button to select sleep time from
"10→20→30→40→50→60→70→80→90→OFF", 5 seconds after you set the sleep time, will
auto confirm the set and activate the AUTO POWER OFF function. If you need power off
midway, press the [AL. OFF/POWER] button; check or change the auto power off time, after
activate the auto power off function, press [SNOOZE/SLEEP] button again, the LED will show
the rest auto power off time, press [SNOOZE/SLEEP] button again can select the next level
auto power off time (Such as: if originally you set "30", after 2 minutes, you check the LED
will show the rest 28 minutes, if you press [SNOOZE/SLEEP] button again, at this time, the
auto power off time will become "40"). If you need turn off the auto power off function,
repeat press [SNOOZE/SLEEP] button, until the LED show "OFF"

VOLUME CONTROL

Press [AL.1/VOL-] button or [AL2/VOL+] button adjust to your desired volume, the volume
have total "0-16" levels, the default volume is 10 level
TIME BACKUP
Install 2pcs AAA 1, 5V batteries. In case of power failure the clock time will continue. If no
backup batteries are inserted the time will recover to a blinking "12:00" or "0:00"after power
failure.

AUX MODE

Press the "func" button to change to AUX mode. [FUNC.] button into AUX mode, connect up
the external sound, the unit will play music, you can press [VOL-] button or [VOL+] button to
the desired volume
9