Declaration Of Conformity; Environmental Protection - Worx WX101 Manual Del Usuario

required rotation position. Push the trigger and the drill
will start to rotate.Check that the battery is charged and
properly connected to the tool.
2. THE DRILL STOPS BEFORE THE SCREW IS
COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque adjusting ring.
Find the torque adjusting ring between the chuck and the
drill body. Position 1 is the lowest torque (screw driving
force) and position 15 is the highest torque (screw
driving force). Position is for drill operation. Regulate
the torque adjusting ring to a higher position to reach
the best result.
3. REASONS FOR DIFFERENT BATTERY PACK
WORKING TIMES
Charging time problems, as above, and having not
used a battery pack for a prolonged time will reduce the
battery pack working time. This can be corrected after
several charge and discharge operations by charging &
working with your drill. Heavy working conditions such
as large screws into hard wood will use up the battery
pack energy faster than lighter working conditions. Do
not re-charge your battery pack below 0
45 C as this will affect performance.
o
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
Your tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage your
power tool.
FOR BATTERY TOOLS
The ambient temperature range for the use
and storage of tool and battery is 0
The recommended ambient temperature
range for the charging system during charging
is 0 C-40 C.
0 0
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
20V Cordless Drill Driver
DECLARATION OF
CONFORMITY
We,
POSITEC Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Cordless Drill Driver
Type WX101 WX101.1 WX101.2 WX101.5
WX101.9 (1-designation of machinery,
representative of Cordless Drill)
Function Drilling, tightening and loosening
screws, nuts
Complies with the following Directives:
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to
EN 55014-1, EN 55014-2, EN 62841-1,
EN 62841-2-1
C and above
o
The person authorized to compile the technical file,
Name
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2020/02/20
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P . R. China
C-45 C.
0 0
Marcel Filz
11
EN