Husqvarna TE 250 2012 Caracteristicas - Uso - Mantenimiento página 103

BRAKE PADS REMOVAL
- Remove springs (1).
- Remove pins (2).
- Remove pads.
CAUTION!
Don't operate the brake lever or pedal while
removing the pads.
2
FRONT
1
REAR
PADS WEAR
Inspect pads for wear.
Service limit " A" is: 3,8 mm (0.15 in.).
If service limit is exceeded, always replace the pads in pairs.
1
A
2
FRONT
PADS CLEANING
Be careful that no disc brake fluid or any oil gets on brake pads
or discs. Clean off any fluid or oil that inadverently gets on the
pads or disc with alcohol.
Replace the pads with new ones if they cannot be cleaned sat-
isfactorily.
PADS INSTALLATION
- Install new brake pads.
- Reassemble the two pins (2) and the springs (1)
2
FRONT
A
REAR
REAR
SPECIFICATIONS - OPERATION - MAINTENANCE
1
1
2
EN - 47