Husqvarna TE 250 2012 Caracteristicas - Uso - Mantenimiento página 104

WARNING!
Do not attempt to ride the motorcycle until
the brake lever or pedal are fully effective.
Pump the brake lever or pedal until the pads
are against the discs.
The brake will not function on the first ap-
plication of the lever or pedal.
EN - 48
SPECIFICATIONS - OPERATION - MAINTENANCE
BRAKE DISC WEAR
Measure the thickness of each disc at the point where it has
worn the most. Replace the disc if it has worn past the service
limit.
Disc Thickness
DISC STANDARD
Front 3 mm
(0.12 in.)
Rear 4 mm
(0.16in.)
DISC CLEANING
Poor braking can also be caused by oil on the disc. Oil or grease
on the disc must be cleaned off with a high flash-point oil free
solvent, such as acetone or lacquer thinner.
SERVICE
LIMIT
2,5 mm
(0.1 in.)
3,5 mm
(0.14in.)