Weber SPIRIT 210 Guia Del Propietario página 12

Check
A) Hose to manifold connection (1) .
m warNiNG: if there is a leak at connection (1), retighten the
fitting with a wrench and recheck for leaks with soap and
water solution. if a leak persists after retightening the fitting,
turn off the gas. do Not oPerate the Grill. Contact
the Customer service representative in your area using the
contact information on our web site.
log onto www.weber.com
B) Hose to quick-disconnect connection (2) .
C) Valves to manifold connection (3) .
m warNiNG: if there is a leak at connections (2) or (3) turn
off the gas. do Not oPerate the Grill. Contact the
Customer service representative in your area using the
contact information on our web site.
log onto www.weber.com
When leak checks are complete, turn gas supply OFF at the source and rinse
connections with water .
reinstall Control Panel
You will need: Phillips screwdriver .
A) Reconnect the igniter wires to the ignition module .
B) Carefully position control panel down and onto frame .
C) Reinstall machine screws at lower left and right side of control panel with a Phillips
screwdriver .
D) Reinstall screw and washer onto the back of the control panel with a Phillips
screwdriver .
E) Replace burner control knobs .
◆
12
GaS INSTrUcTIoNS
.
®
.
®
1
3
2