Sears Kenmore 795.7203 Manual De Uso página 42

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

TROUBLESHOOTING GUIDE
ICE & WATER
Problem
Icemaker is not
making ice.
Not dispensing water. New installation or water line recently
Possible Causes
Refrigerator was recently installed or
icemaker recently connected.
Icemaker not turned on.
The ice detecting sensor is obstructed. Foreign substances or frost on the ice-detecting sensor
The refrigerator is not connected to
a water supply or the supply shutoff
valve is not turned on.
Icemaker shutoff (arm or sensor)
obstructed.
Reverse osmosis water filtration
system is connected to your cold
water supply.
connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
Refrigerator or freezer doors are not
closed properly.
Water filter has been recently
removed or replaced.
Tubing connecting refrigerator to
house supply valve is kinked.
The house water supply is not
connected, the valve is not turned on
fully, or the valve is clogged.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Locate the icemaker ON/OFF switch and confirm that
it is in the ON (I) position.
can interrupt ice production. Make sure that the sensor
area is clean at all times for proper operation.
Connect refrigerator to the water supply and turn the
water shutoff valve fully open.
If your icemaker is equipped with an ice shutoff arm,
make sure that the arm moves freely. If your icemaker
is equipped with the electronic ice shutoff sensor,
make sure that there is a clear path between the two
sensors.
Reverse osmosis filtration systems can reduce the
water pressure below the minimum amount and result
in icemaker issues. (Refer to the Water Pressure
section.)
Dispense 2.5 gallons of water (flush for approximately
5 minutes) to remove trapped air and contaminates
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
Press and hold the Lock button for three seconds to
unlock the control panel and dispenser.
The dispenser can be set for ice or water. Make
certain that the control panel is set for the proper
operation. Press the Ice/Water Select button on the
control panel.
Water will not dispense if any of the refrigerator
doors are left open.
After the water filter is replaced, dispense 2.5 gallons
of water (flush for approximately 5 minutes) to remove
trapped air and contaminates from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF.
The tubing can kink when the refrigerator is moved
during installation or cleaning resulting in reduced
water flow. Straighten or repair the water supply line
and arrange it to prevent future kinks.
Connect refrigerator to the water supply and turn the
water shutoff valve fully open.
If the problem persists, it may be necessary to contact
a plumber.
42
Solutions

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

720327203972033

Tabla de contenido