Turning The Burner Off; Turning The Appliance Off - Tecnoinox FTL4G9 Manual De Instrucciones

Part 3
Press and turn knob "A" (pic.4) from position "
pressed in.
At the same time, press the ignition button "B" (pic .4) repeatedly
until the pilot flame has lit up.
After the flame has lit, hold the knob down for approximately 10
seconds (count to 20); so, the thermocouple heats up and the safety
valve can be kept open.
To light the main burner on, turn the knob until it reaches the desired
position.
Note: if the piezoelectric device cannot be used, you can
alternatively light the flame by using a match or a gas lighter.
Regarding models FTC4_G9 and FTC8_G9, turn the knob from
position 1 to 7 to obtain the desired temperature; the appliance
reaches its maximum temperature in position 7 (~300°C).
The appliance has a fat recollection drawer "V" (pic.2) located on the
front part of the control panel.
In case of overheating (due to improper use or to a faulty
component) the safety thermostat "E" (pic .1), placed at the bottom of
the appliance, will operate. It automatically cuts off the gas supply to
Turn off the gas cock installed upstream the appliance.
Turning the burner on and off
●
" to " ", keeping it
Fat recollection drawer
Safety thermostat only on model FTC_G9
What to do if the appliance is not going to be used for a long time
For models FTL/R4_G9 and FTL/R8_G9:
Off

TURNING THE BURNER OFF:

Turn the knob from the current position to the " " position.

TURNING THE APPLIANCE OFF:

Turn the knob to the "
Empty the drawer before using the appliance.
the burners. When such device operates, close the gas cock placed
upstream of the appliance and inform the after-sales service.
Clean the appliance with soapy water, rinse, dry carefully and apply
a light layer of white mineral oil.
GB / IE - 4
pilot light Burner MAX
●
" position.
Use
Burner MIN
5410.289.00