Rear Panel - Pioneer SC-LX501 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

> Before start
> Hookup

Rear Panel

1
12
1. COMPONENT VIDEO IN jacks: Input the video signals
from AV components with a component video cable.
2. ZONE 2 PRE/LINE OUT jacks: Output audio signals with
an analog audio cable to a pre-main amplifier or a power
amplifier in a separate room (ZONE 2). (
3. AUDIO IN jacks: Input the audio signal from AV
components with an analog audio cable.
4. VIDEO IN jacks: Input the video signals from AV
components with an analog video cable.
5. HDMI IN jacks: Transmit video signals and audio signals
with a HDMI cable connected to an AV component.
6. SIGNAL GND terminal: The ground wire of the turntable
is connected.
7. HDMI OUT jacks: Transmit video signals and audio
signals with a HDMI cable connected to a monitor such
30
> Setup
3
2
4
5
13
14
15
as a TV or projector.
8. NETWORK port: Connect to the network with an
Ethernet cable.
9. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input the
P18)
digital audio signals from TV or AV components with a
digital optical cable or digital coaxial cable.
10.Wireless antenna: Used upright for Wi-Fi connection or
when using a BLUETOOTH enabled device. The
diagram shows the movable range for the wireless
antenna. Do not try to force it beyond this range
otherwise you may break it.
11. AC IN: The supplied power cord is connected.
12.RS-232C port: For connection to the home control
system.
13.ANTENNA AM LOOP/FM UNBAL 75Ω terminal: The
> Playback
> Part Names
6
7
8
9
16
17
10
11
supplied antennas are connected.
14.IR IN/OUT port: Allows you to connect a multiroom
remote control kit.
15.12V TRIGGER OUT A/B jacks: Allows you to connect a
device with 12V trigger input jack to enable link operation
between the device and the unit.
16.SUBWOOFER PRE OUT jacks: Connect a powered
subwoofer with a subwoofer cable. Up to two powered
subwoofers can be connected. The same signal is output
from each of the SUBWOOFER PRE OUT jacks.
17.SPEAKERS terminals: Connect speakers with speaker
cables. (North American models are compatible with
banana plugs.)
10

Publicidad

Tabla de contenido
loading

Tabla de contenido