Rear Panel - Pioneer ELITE SC-LX502 Manual Básico

> Before Start > Part Names



Rear Panel

1. COMPONENT VIDEO IN jacks: Input the AV component video signals with a component
video cable. (Compatible only with 480i or 576i resolution.)
2. ZONE 2 PRE/LINE OUT jacks: Output audio signals with an analog audio cable to a pre-
main amplifier or a power amplifier in a separate room (ZONE 2).
3. AUDIO IN jacks: Input AV component audio signal with an analog audio cable.
4. VIDEO IN jacks: Input the AV component video signals with an analog video cable.
5. HDMI IN jacks: Transmit video signals and audio signals with a HDMI cable connected to
an AV component.
6. HDMI OUT jacks: Transmit video signals and audio signals with a HDMI cable connected
to a monitor such as a TV or projector.
> Install > Initial Setup
   
  
> Playback
   
 
7. SIGNAL GND terminal: The ground wire of the turntable is connected.
8. NETWORK port: Connect to the network with an Ethernet cable.
9. DIGITAL AUDIO IN OPTICAL/COAXIAL jacks: Input TV or AV component digital audio
signals with a digital optical cable or digital coaxial cable.
10.Wireless antenna: Used upright for Wi-Fi connection or when using a BLUETOOTH
enabled device. The diagram shows the movable range for the wireless antenna. Do not
try to force it beyond this range otherwise you may break it.
11. AC IN: The supplied power cord is connected.
12.RS-232C port: For connection to the home control system. (*)
13.ANTENNA AM LOOP/FM UNBAL 75≠ terminal: The supplied antennas are connected.
14.IR IN/OUT port: Allows you to connect a multiroom remote control kit. (*)
(*)You can find details in the Advanced Manual.
 

En 5